DM1100 CT is a single side cross belt machine which removes oxide layer from oxygen laser cut steel parts both on the inside and outside areas.
Also, by replacing the cross belt set for edge rounding type this machine can remove sharp edges of stainless steel, steel and aluminium parts cut by laser, punching or shearing. This deburring machine can work parts longer than 180mm and as a table with 1100mm width. For smaller parts edge rounding please contact us for our DM1100 C.
Principle of work: 2 v-belts with abrasive blocks or oxide removal wire brushes running in opposite directions guarantee that all sides on the top surface and upper half thickness will be cleaned from oxide or edge rounded in one single pass.
Both sides, single side and before oxide removal steel samples
Oxide Removal: removing oxide layer from thickness of steel parts up to 8mm in one pass or up to 16mm in 2 passes. Cleans simultaneously internal holes.
DM660 ZPK is a deburring machine for sheet metal and parts cut by punching, shearing, laser or plasma.
DM660 ZPK features an integrated vacuum table and a 3 movement system of the brushing head, assuring a high consistency. It is possible to work parts up to 660mm width and some as small as 50x50mm.
This machine can perform rounding on small holes, bended plates and create big radius up to 2mm.
By blocking the rotation head this machine can be used for surface finishing in a configuration of wide belt and double parallel brush.
On DM660 ZPK it is easy to interchange brushes, so it is possible to achieve rounded edges free from burrs or sharp corners but also to clean oxide layer.
When operating with steel planetary brushes DM660 ZPK removes efficiently the oxide layer on interior and exterior contours of laser-cut steel sheets.
DM660 ZPK cleans oxide layer in 2 step operation on parts from 4mm up to 25mm thick.
Preparing steel cut parts for coating by removing oxide layer will improve the ability of the parts to be coated. Powder coating or wet paint adheres well to the oxide layer. However, when the surface is damaged or subject to impacts the oxide layer can detach from the material, limiting the lifetime of the coating.
DM660 ZPK performs oxide removal with flexible and efficient wire brushes, leaving the parts oxide free and ready for further coatings.
See the demonstration video below of this oxide removal machine where steel parts are brushed from oxide.
